Our website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish.

close

Weatherproof Lightning Surge Protector for RS-422/RS-485 & 24VDC Power Lines

ALS-D25P24DW
New product

173,32 €tax excl.

209,72 € ( IVA Incluido )
The stock of this article is reserved or is minimal. You can buy it, but we will confirm the final availability when processing the order. (max 24 hs)

- +

Add to compare

 
More info
The HyperLink ALS-D25P24DW is designed to provide superior lightning and surge protection for RS-422/485 control and 24VDC power lines. These protectors incorporate individual protection circuits for the RS-422/485 control lines and DC power lines. All housed in one NEMA rated weatherproof enclosure.

RS-422/485 Control Lines

A high power 3-stage design is used to provide protection for the RS-422/485 control line. The 3-stage design can handle higher-level transients than a protector that uses only diodes. The first stage is comprised of a differential gas discharge tube. Stage two is a pair of current limiting series resistors and the final stage is a low capacitance diode array. The RS-422/485 control line is connected to the protector via its screw terminal blocks. The terminal blocks are removable to ease wiring. The ALS-D25P24DW is designed to work with either 1 full duplex or 2 half duplex RS-422/485 lines.

24VDC Power Lines

The 24VDC power lines are also protected using a 3-stage design. This provides superior protection from transients and surges. The first stage is comprised of a differential gas discharge tube. Stage two is a pair of suppression coils and the final stage is a 5000 Watt uni-polar Transient Voltage Suppression (TVS) Diode. Power lines are connected to the protector via high current rated screw terminals.

Weatherproof Design

These units feature a weatherproof ABS enclosure with gasketed cover and concealed mounting holes. Water tight cable glands provide entry and exit points for cables. A ground clamp on the enclosure's exterior provides a tie point for earth ground.

For mounting to masts up to 2 inches in diameter, the HGX-PMT24 mast mounting kit is available (sold separately).

This protector is also available in the following power configurations:
12VDC: ALS-D25P12DW
15VDC: ALS-D25P15DW
12-28VAC: ALS-D25P1228AW

For additional information and complete specifications, click on the data sheet link below.

3 other products in the same category:

Compare 0

No products

To be determined Shipping
0,00 € Total

Check out